tooantc Posted November 13, 2006 Report Posted November 13, 2006 I need to know the torque specs for putting the cases together. There are different torque specs for the upper and lower screws. Thanks for the help. Quote
banshee332 Posted November 13, 2006 Report Posted November 13, 2006 I need to know the torque specs for putting the cases together. There are different torque specs for the upper and lower screws. Thanks for the help. The bottom nuts i torque at 20 ponds and the ones on the top i just give them a good snuge :biggrin: Quote
tyguy Posted November 13, 2006 Report Posted November 13, 2006 do a search there is every spec you need.... 8 for the top 20 for bottom Quote
alisn4x4 Posted November 13, 2006 Report Posted November 13, 2006 do a search there is every spec you need.... 8 for the top 20 for bottom straight from the clymer's manual.... they want the initial 3 1/3 ft-lbs bottom then top, then 7 ft-lbs second time, all while following the number sequence as stamped on the cases. i then tightened them down to about 20 lbs and made sure they were all nicely even and tight. Quote
tyguy Posted November 13, 2006 Report Posted November 13, 2006 yeah i seen the top should have been at 7.4 but i just did 8...better i bit over than under.... :thumbsup: yes remeber to follow the case numbers... youll be good to go.... Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.