no idle?

[Eddie]

hi i was wondering if anyone could tell me what the hell is going on with my shee. The only mods on it are removed snorkel, K&N filter, clip on needle jet changed to fourth position, #190 main, stock air pilot needle, i have synchronized the carbs, but need to know what to set my air pilot screw to, my elevation is 2191 feet, current temp is 0-20 degrees celsius. The throttle is sticking, and it is idling irratically when i take the choke off if at all, any help would be greatly appreciated im stuck

[dajogejr]

I think you're a hair lean on your main, despite your elevation...however, that won't fix your idle.

 

Try unplugging your TORS system. Do a search here, [email protected] has a thread will illustrations on how to unplug it.

[Eddie]

it doesnt seem to stick now or idle irraticaly since i have resync'd it to near perfection, although one side does seem richer than the other... i believe it is my airpilot screw, if anyone could give me an idea of what to set it to that would be great

[[email protected]]

check out my thread on the tors , its in the bottom of my sig

 

also make sure the cross over tube between the stock carbs is connected.

[dajogejr]

warm the bike up completely.

Turn each air screw all the way in. Turn it out 1/2 turn, wait 20 seconds for this setting to take effect. Keep going out 1/2 turn at a time, waiting each time, and get the highest idle you can.

 

Then the air screws are set.

[Eddie]

Thanks for the quick response everyone, i will set the airscrews as following, and remove the TORS system to see if that solves the problem and will repost with the results.