Bansh-eman Posted September 19, 2006 Report Posted September 19, 2006 hey what are you guys using to smooth out the cuts on your plastics? Quote
[email protected] Posted September 19, 2006 Report Posted September 19, 2006 i use a hot blow torch , and i run it very lightly , very fast over the edges that have been sanded allready with some fine grit, then i rub with some 1000 gritt paper while its barely warm , leaves a gloss finish Quote
Bansh-eman Posted September 19, 2006 Author Report Posted September 19, 2006 i use a hot blow torch , and i run it very lightly , very fast over the edges that have been sanded allready with some fine grit, then i rub with some 1000 gritt paper while its barely warm , leaves a gloss finish yea i was thinking to heat them up after i sand the ruff out .... any others? Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.