bansheeryder21 Posted September 12, 2006 Report Posted September 12, 2006 I just have a easy question regarding the installation of these things. I already cut my stock intakes to get them to fit! My question is, do I remove the center plastic piece that comes in the Vforce 3's? I don't think I'm supposed to remove it, but want to make sure! It doesn't say anything in the instructions. Also, am I going to have to rejet my carbs? If so, lean or richin? Quote
MFIC Posted September 12, 2006 Report Posted September 12, 2006 I just have a easy question regarding the installation of these things. I already cut my stock intakes to get them to fit! My question is, do I remove the center plastic piece that comes in the Vforce 3's? I don't think I'm supposed to remove it, but want to make sure! It doesn't say anything in the instructions. Also, am I going to have to rejet my carbs? If so, lean or richin? It needs to stay in and for jetting move your needle down a notch. Quote
dajogejr Posted September 12, 2006 Report Posted September 12, 2006 I removed mine and put a steel plate the size of the opening on mine...no problems... You may or may not have to lean out the needle (the clip towards the blunt end one)... It richens the middle circuit...sometimes it's a little boggy without leaning the needle. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.