what are these for?

[awesomeame]

could someone tell me what these wires are supposed to be for? they're disconnected and appear to be going to the carburetor. why would someone disconnect these? thanks

 

 

--matt

[Hilarious]

Those would be plugged into the TORS units found on top of

stock carburetors. TORS = throttle override system. I wouldnt

be worried about them. If you run them down the frame and see

where they go, you would find that they lead to a little box under

the gas tank on the left side of the frame. You should remove it

and toss it to the wind also.

[awesomeame]

what's the TORS supposed to do, like besides the obvious

 

--matt

[Hilarious]

The TORS is supposed to be a fail safe incase your carburetor slides get

stuck wide open with the engine still running. Not a very fun experience

especially with a banshee. Lol. The TORS seem to be more of an electrical

nightmare than anything else.

[[email protected]]

CUT THEM OFF !!!!!!!!!!!!!!!!! and use butt crimp connectors and seal the wires off and tape them forever to the wire harness !!!!!!! GARBAGE !!!!!!!!!!!!!!!!!!!!!!!