good starting point

[badassbanshee479]

need a base line for a 350 stock cylinder bike with milled head, small bore shearers and a clean up port, also running boyson reeds on stock cages, this is my play bike for now. just need a good place to start with stocker carbs. oh k&n clamp ons too!!

[dajogejr]

340 or 350 main.

27.5 pilots.

Toomey (dynojet needles if you can get 'em) Stock needles have a lean spot in 'em.

middle clip on stock needles, 4 clip from blunt end if you get teh dynojet needles.

Air Screws 1.0 to 2.0 out.

 

I had 330's and the above on mine..JT, with Toomeys. I'm assuming the shearers will flow a little more...

 

I'd say 350 would be safe. Porting could make that go a little up or down...too.

 

Good luck!

[badassbanshee479]

sounds good thanks