gregbowler Posted May 16, 2006 Report Posted May 16, 2006 just bought a set of DMC 916 pipes for my 1997 banshee and am looking for an idea of where to start for jetting. Mods are as follows: no snorkel k&n w/adapter carbon tech reeds in the stock cages TORS removed 240 mains 25 pilot 1 1/8 on the air screws clip second from the blunt end Would like suggestions for sea level and sand mountain NV Thanks in advance Quote
Hilarious Posted May 17, 2006 Report Posted May 17, 2006 @ sea level, take the lid of and try some 320's to 340's. With the lid on, 300's. You may wanna drop those clips a notch or two also. Quote
gregbowler Posted May 17, 2006 Author Report Posted May 17, 2006 (edited) EDIT: clip is in the 4th from the blunt anyone else??? (bump) Edited May 17, 2006 by gregbowler Quote
dajogejr Posted May 17, 2006 Report Posted May 17, 2006 Needle in the middle Stock Pilots. With the lid on, 270, lid off, 280 to 300. With K&N Pods, no air filters, T5s and at about 600ft elevation, I ran 330 mains and it was spot on... Quote
i12gofast Posted May 17, 2006 Report Posted May 17, 2006 I got 916's at 900ft asl and im running 360's and im not there yet, still a tad lean. Clip is 4 down from the top and i went up one size on my pilots. Practically sames mods as you too, 01 shee. Quote
gregbowler Posted May 17, 2006 Author Report Posted May 17, 2006 I hope I don't need to go that big !!! I bought 280,290 and 300 mains to take to sand mountain for memorial day weekend. Will I be OK ? Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.