electrical help

[izericson]

hey i rebuilt my shee and wired the lights so they would be on brights all the time. i wanted to clean up the bars so now i have a pushbutton lill and no option of on/off/bright/dim. its just bright as soon as i kick her over. i was told to wire basically yellow to yellow to achieve this. the first night i was gonna start her i did a spark check and it was fine so i fired her up and she ran great, the lights worked and all. so i ran all my wires, zip tied where i needed to and finished her off. when i went to start breaking in my new engine in noticed the headlights nor taillights worked anymore. the only thing i did from the time they worked that first night till they didnt was disconnect and reconnect the plug that goes from the engine to the main harness. now keep in mind that the quad still runs great. starts up fist kick just no lights. i am pretty sure the way i wired it is correct. i got the info from a good source plus looking at the wire diagram in the clymer it all makes sense. the next step for me is to get a mulitmeter and read for voltage at the lights. any suggestions. thank you all very much.