need a baseline for 30 mm oko's

[sexypizzaguy]

im having some problems jetting my banshee. what i have is a 4mil stroker t5's cool head delta force reeds 30mm oko carbs & k&n's. it has 170 lbs of compression. i run 110 race gas and redline oil mixed at 40:1.the port job was done by me using race logic template kit. i also flowed the cylenders on my friends superflow flow bench but i did this so long ago i cant rember the numbers. i also use a exhaust gas temp guage made by racepak to aid in jetting. im fairly shure i have my main jet right. i currently have a 165 main. my egt at wot is 1250 degrees f. my problem is its kinda boggie down low and it seems to have a lean kackle at about 1/2 throttle but only under load. i currently have a 55 piolet and a n68a neddle with the clip in the 3rd position from top. no matter what i seem to do i cant seem to work it out. anybody else with my combination that could help? o yeah im at sea level. thanks seth

[wesw]

my brother in law he put those on his bike.

 

55 pilot, n80f needle or somethign like that, adn 150 mains it ran pretty well.

 

those needles are hard to figure out no charts to compare to or anything.

you might raise your needle clip at a time to see how it acts.

 

best of luck with them