apbt549 Posted April 25, 2006 Report Posted April 25, 2006 Will it hurt anything if i modify my pro design intake so i can use the v-force 3 reeds.it has a square male peice on the back i grind or mill off b/c the v-force reeds have a round hole in them.that shouldn't hurt anything should it b/c the gasket is on the out side of this square piece .....the gasket will still seal it off with no problem it looks like.has anybody else done this? problem is male square will not fit into round hole..... Quote
bansheeseat$$ Posted April 26, 2006 Report Posted April 26, 2006 (edited) It will not hurt anything.Just like when you had to remove the insurt on the stock intakes to work with the v-force reeds. Edited April 26, 2006 by bansheeseat$$ Quote
pipebomb Posted April 26, 2006 Report Posted April 26, 2006 nope, won't hurt it at all as long as you cut the mounts for the deflector plate off about an 1/8" ( i used a scrap piece of thin sheet metal as a spacer) out from the face so you don't gouge it and then gently/slowly grind the excess off so it's flush w/ the mating surface. Had to do mine like that after I bought my VF2's. mine came out looking just like factory. just take your time and go slow. Quote
apbt549 Posted April 26, 2006 Author Report Posted April 26, 2006 tks guys i didn't think it would hurt but want to make sure Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.