bt's shee Posted September 30, 2005 Report Posted September 30, 2005 I have an all stock 2004 Banshee. The bike was jettted correctly (good lookin plugs and relatively smooth operation) with the TORS installed. After installing the Motion Pro kit, Sheee is running rich everywhere, but the top end is not real bad. I have checked the float level (21mm) cleaned the carbs 3 times, lowered the needle to the 4th position, and tried tweeking the pilot screw in 1/4 turn increments from 3 turns out to 1.5 turns out. Lots of white smoke, plugs soaking wet everytime. Anybody have this happen before? Quote
bt's shee Posted September 30, 2005 Author Report Posted September 30, 2005 I synchronized the carbs using the visual technique and my hand. Did'nt pay attention to the little windows in the side of the carbs or the slide taper. THe slides were in backwards. duh Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.