HELP banshee left cylinder

[Deezy804]

I rode my banshee and the next day I go to ride the left cylinder is dead I know it's gettin fuel cause my headers fill up with gas that isn't burning and when I empty the header of the extra gas it fires case it's pushing the rest of the gas out but it's very weak. and it is getting fire so what y'all thinks the problem

[Phelps]

you need fuel, compression and spark. you have already ruled out fuel. 

[Deezy804]

Compression and spark good .. 60 over brand new wiseco pro lite... When I start it the header fills up with gas but when I dump it it fires really weak and fills up again

[Phelps]

check the float needle. compression is good because it's a new topend? you know how many 5 minute old topends i have seen with a broken ring because the ports were not chamfered? 

[Deezy804]

Yea I think it's the dam float to man I don't even have 5hrs on the fresh top end, also hear it could possibly be bad reeds but I kinda doubt that but def considered it

[sheerider11]

It takes 2 minutes to do a comp test. Also rule out another possible issue.

Like stated, just because it's new that doesn't mean it's okay.

I'd do that before I start taking shit apart also. Do all the simple test.

Then you can visually check if you have spark too.

[fastbanshee8]

Bad spark plug boot, check pick-up gap on the flywheel, besides the other stuff that has been mentioned.

[Deezy804]

I was just riding the bike a day before and this happend all of a sudden but I'm taking the carb off tomorrow and check the float and I'll keep you guys posted and thanks

[Phelps]

while the carb is off do the best you can with a light to inspect the reeds. 

[Larry's Shee]

Take carb completely apart and clean it, set float s

[sleeper06]

Reeds

[Deezy804]

Thanks fellas come to find out it was the piece that works the slide from the throttle , the screws came out and the slide was never moving n the carb