Rebuild won't start after first start

[bluebanshee7]

Okay so I rebuild my banshee to stock after frying a crank bearing. Only upgrade is FMF pipes.

 

27.5 pie

280 main

uni air filter in airbox

fresh plugs

 

Did a leak test and found a small leak between my reed cage gasket. Fixed the problem and had no other leaks.

 

Got the shee started and let it run a little. Let her cool down over night and was going to start the break in process the next day. Started first kick today, ran it at idle for 10-15 min, let it cool for 2 hours, went to start it and couldn't get it started. It almost starts up but never runs. Any ideas?

 

I used a bit of rtv between the gasket that is on the carb side of the reed cage. When I pulled my plugs to check them there was 2 pieces of rtv around the plug. Could the rtv maybe be getting lodged between my reeds or messing something up? Could possibly clog my carbs?

[bluebanshee7]

why'd ya use rtv? its not gas resistant........ probably didn't clog the carbs but I bet your air leak is back

I could of sworn I saw someone use rtv in a video. I'll have to take it off and get a new gasket and do leak test again