Carb size?

[Vinny_Vincenzo408]

Looking to get new carbs for my banshee what's a good size to get? I ride at pismo dunes my mods so far are toomey t6 pipes vforce reeds advanced timing plate boost bottle

[Pastrykiller]

Stocks are just fine. That motor is far from needing carb mods.

[Vinny_Vincenzo408]

My stock carbs are done the threads on top of the carbs are stripped so I should get a new set of stock carbs? I'm planning on doing a 4 mill setup in the future if that would make a difference

[Pastrykiller]

33 pwk's on a 4 mil is ideal. When u say tops are stripped...carbs or carb caps? I have a new set of tops if you need em. If not, I have a set of stock carbs that will have the new caps on them as well.

[Pastrykiller]

Btw- pwk 33's and 35's have the same bodies. You can bore a 33 to a 35 if you need that size in the future.

[Vinny_Vincenzo408]

The carb is stripped. Would those be good if I were to run those on my setup for now? No thanks I'm still trying to decide if I should just save my money an start the 4 mil build

[Vinny_Vincenzo408]

Thanks that's good to know

[dirtydownunder]

get some cheap stock carbs, and run them on the 4mm, when ever that happens. then buy bigger carbs later.

[Starwriter]

get some cheap stock carbs, and run them on the 4mm, when ever that happens. then buy bigger carbs later.

I agree. Big carbs on a stock unported motor will make it a pig.