chris_sims1981 Posted October 1, 2013 Report Posted October 1, 2013 I'm still very new to quads but I'm learning. I looked in the yamaha repair manual and it doesn't give details on how to remove the clutch push lever. Could anyone give me a few details on how to remove it? Quote
sheerider11 Posted October 1, 2013 Report Posted October 1, 2013 Pull it out. its easier with no clutch pressure. 1 Quote
SAVAGE420 Posted October 1, 2013 Report Posted October 1, 2013 Yes as said above, the clutch actuator arm just pulls out when you undo the bolt that holds the retainer. The CLYMERS shows detailed pics and detailed details all about it...not like the bunk ass SHITTY yamajunk manual Quote
chris_sims1981 Posted October 1, 2013 Author Report Posted October 1, 2013 Wow! That simple, thanks Quote
SAVAGE420 Posted October 1, 2013 Report Posted October 1, 2013 Just be carefull a bit not to mess up the seal...don't pry on it, just twist it back and forth while pulling up. Inspect bearing and seal, replace them both if they need it. Cheap parts to buy. Quote
chris_sims1981 Posted October 1, 2013 Author Report Posted October 1, 2013 I'm gonna order the Clymer's tomorrow Quote
Starwriter Posted October 1, 2013 Report Posted October 1, 2013 Uh, I've never tried removing the clutch actuator without 1st removing the clutch pushrod, but I'm pretty sure the pushrod is going to stop you from removing the actuator. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.