atcandbanshees Posted May 16, 2013 Report Posted May 16, 2013 Need to figure out where and what to get to drill jets for alky Quote
Finch Posted May 16, 2013 Report Posted May 16, 2013 do ya know what size ya think ya need? id buy a few sizes around that. Quote
atcandbanshees Posted May 16, 2013 Author Report Posted May 16, 2013 Well its running fat and its .116 Quote
atcandbanshees Posted May 16, 2013 Author Report Posted May 16, 2013 I tried snd still wasn't enough Quote
dajogejr Posted May 16, 2013 Report Posted May 16, 2013 Just buy a cheap set from harbor freight. If you made your living as a machinist/fabrcator...I'd say buy a nice set. But then again, if you either of those, you wouldn't be asking that question...LOL. You'll need .110 to .124. Your main might be .116, but what is the dump tube? And what kind of needle...and what clip is it on? You say tuning it in with the PJ still wasn't enough...does that mean you closed the PJ all the way and it was still fat? Quote
atcandbanshees Posted May 16, 2013 Author Report Posted May 16, 2013 Ya I closed it all the way. It would launch but then just fall on its face after. My needle was set in middle postion and my dump tube was also .116 that's what was scribbed in thw side atleast Quote
dajogejr Posted May 16, 2013 Report Posted May 16, 2013 I'm going out on a limb...but I think you may have other problems. Ignition comes to mind. Quote
atcandbanshees Posted May 16, 2013 Author Report Posted May 16, 2013 I kinda thought the same. But what do you think it could be. It will rev up and clean out but there is raw alky coming out the pipes. Ill dump the clutch in second then it just falls flat on its face then try to get going again but its off and on 1 Quote
dajogejr Posted May 16, 2013 Report Posted May 16, 2013 Where did the complete ignition system come from before this? Is this all KNOWN working parts...or pieced together from sales, ebay, etc.? Is it a Ricky Stator, aftermarket coil, shaved flywheel, etc? Quote
atcandbanshees Posted May 16, 2013 Author Report Posted May 16, 2013 Came off my 96 and no fly wheels not cut but the stator had some soldiering done Quote
dajogejr Posted May 16, 2013 Report Posted May 16, 2013 And that's why I asked if it was Ricky Stator... Get a known working good stator. Then open those PJs all the way up... You're gapping the plugs down to .018 or so, right? Quote
atcandbanshees Posted May 16, 2013 Author Report Posted May 16, 2013 Ill check to see if its a ricky stator and ya I gapped the plugs to.018 what plugs do you recommend Quote
dajogejr Posted May 16, 2013 Report Posted May 16, 2013 BR8ES...standard always works fine. While you're at it...once you remove the flywheel, shake it and listen for broken magnets. If they're bad, you'll hear them shaking around inside like a maracca. Quote
atcandbanshees Posted May 16, 2013 Author Report Posted May 16, 2013 Alright. Should I try to find a stock stator or get a racetech Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.