Cutting Fenders and Powder coating frame

[87BRBanshee]

Hey guys, finally got a start on my shee. Laid out some tape and started cutting. Got the fronts about where I want them just got to go through and clean them up a bit and het then even. Not sure how I want the backs yet. But once I get those done I'm gonna cut unnecessary tabs and strip the frame down to have it powder coated black. Will keep you guys posted with pics and details.

 

 

 

 

 

 

 

 

Sent from my HTC One X using Tapatalk 2

 

 

[87BRBanshee]

Got the back taped up and ready to cut

 

Sent from my HTC One X using Tapatalk 2

 

 

[springer]

i always liked the rears cut just a little narrower... the line/bend in them just a couple inches in from your tape creates a nice point at the back when cut there.  but good luck.  get that thing powder coated and get a common color theme going, haha.

[87BRBanshee]

i always liked the rears cut just a little narrower... the line/bend in them just a couple inches in from your tape creates a nice point at the back when cut there.  but good luck.  get that thing powder coated and get a common color theme going, haha.

 

 

See I kinda wanted the rears cut a little narrower like you were saying. I might just end upo cutting them back but i wanted to start there. And i've always really like the blue/black theme its not really common around here. Im like the only one in the county with a Banshee. There was one for sale close but was stolen from the road.

[springer]

ya, guess you can always cut more off, but not really put more back on

[007banshee]

See I kinda wanted the rears cut a little narrower like you were saying. I might just end upo cutting them back but i wanted to start there. And i've always really like the blue/black theme its not really common around here. Im like the only one in the county with a Banshee. There was one for sale close but was stolen from the road.

Im not too far from ya.