Cylinder troubles

[llehctim23]

I recently posted about my Banshee problems. Runs like only one cylinder is firing, but then sometimes it runs fine. It all started one day when I was riding down the road and hit a bump and it started bogging out. But it doesn't want to start unless I pull start it. Could this have anything to do with wires not getting connection? So pretty much I'm thinking only one cylinder is firing half the time and don't know why.

[shakar]

heres a start check wire conections, then coil ,wires, caps stator ..do you still have the tors or ebrake wiring??also choke tube hooked up properly between carbs ?? goodluck

Edited September 18, 2012 by shakar

[#1JUANstunna]

I recently posted about my Banshee problems. Runs like only one cylinder is firing, but then sometimes it runs fine. It all started one day when I was riding down the road and hit a bump and it started bogging out. But it doesn't want to start unless I pull start it. Could this have anything to do with wires not getting connection? So pretty much I'm thinking only one cylinder is firing half the time and don't know why.

 

Have you changed plugs, checked the plug caps, clean the flywheel.

 

Have you switched plug wires from side to side to see if the problem switches sides.

[llehctim23]

I put new plugs on right before it happened so I didn't think that would be it but I will give that a try too and check the wires and switch them to see if the other side does the same thing. Thanks for the help.