FIRST banshee, FIRST rebuild. HELP PLEASE?

[tngnst9]

So this is my first banshee. I bought the bike in pieces completely. I have put it all back together and rebuilt the motor with the help of everyone on here!! All that is left is to put the electrical in and the motor and start it up. I cant figure out where to bolt down the electrical stuff or where it goes. I also cant tell by the pics in the manual how the front mount brackets go in. Can someone take some close up pics of their electrical from the spark plugs to where the black boxes bolt down and the front engine mounts? Also, the final steps from putting the engine in to starting it up(put engine oil in tranny so far)? Obviously I have to put gas and coolant in but other than the electrical and hooking lines up anything else i should know? I just dont want to f*** this up since im so far into it. sorry for the dumb questions. I'm new to this whole thing. Again sorry for the newb questions. better safe than sorry.

[007banshee]

CDI and volt regulator bolt to back under seat, coil is under gas tank. Plug in your stator and everything kinda falls into place. Just zip tie away.from moving parts and exhaust. Fill up all fluids check compression and leakdown check spark and kick it!

[tngnst9]

CDI and volt regulator bolt to back under seat, coil is under gas tank. Plug in your stator and everything kinda falls into place. Just zip tie away.from moving parts and exhaust. Fill up all fluids check compression and leakdown check spark and kick it!

What is leakdown check? Not sure how to do a compression check but i think i have watched a video on youtube about it i can find again. I read on here that I need to re-torque bolts after I break it in? they are talking about the frame right and not the actual motor? Also, it came with 2 k&n filters... Do they just mount right up to the carbs? The guy that sold me the bike has not answered the phone since i bought it off him so im clueless.