What size carb to run on a 2 into 1?

[KarTek]

I tried searching for "2 into 1" and the system rejects it so I have to ask. What size carb would work on the Serval with a 2 into 1 intake?

 

Thanks!

[dcalsv02]

I tried searching for "2 into 1" and the system rejects it so I have to ask. What size carb would work on the Serval with a 2 into 1 intake?

 

Thanks!

 

I'm running a 35 pwk, but i don't have a serval. I would guess that a 35 or a 38 would do fine. You will probably hear a lot of pele tell you to skip the 2 into 1 and go with 2 carbs. What manifold are you gonna run?

[KarTek]

I have a bad habit of fabricating stuff like that myself...

[dcalsv02]

Word. Well if you end up looking into a pre made manifold, I would recommend cascade innovations manifold. Here is cascade's manifold compared with trinity's

http://bansheehq.com/forums/index.php?showtopic=150011&st=0&p=1295216&fromsearch=1entry1295216

[Burt Reynolds]

35-38

[ticktock]

Yes 2-1 normally takes te 35-38. It will give you the fuel and air you need for your motor. Of course jetting will be a concern. Start pilots around 60 and go up or down from there!

 

Adam

[KarTek]

Great, thanks! That's exactly what I needed to know.

[ticktock]

Oh, I had a pj38 and I could not dial it in. I switched to pwk35 EEK needle 60 pilot 185 main. I have T-5s, and bored 40 over. It runs strong with an intermittent bog. I think it's something single carbs live with. Troyzstang also has the same prob w/his. Could be normal..

 

Adam

[dcalsv02]

If I remember correctly! I'm running a 195 main and a DEK needle. 35 pwk. Can't remember off the top of my head what pilot. Snappy from top to bottom. No bog anywhere. That was with the trinity manifold though. I haven't tested the new cascade manifold I put on yet.