gapanic Posted May 26, 2011 Report Share Posted May 26, 2011 I have a used set of front works dual rate shocks. They came on my banshee so i dont know what they are set up for. They measure 14 3/4" and were on stock width arms. There is some oil build up on them so i think they need a rebuild. A little rust on the springs also, check the pics. Asking $100 shipped I also have a snapon tapered reamer used to enlarge the hole on your spindles to accept bigger ball joints (some older arms have big ball joints). I think i paid $50-55 asking $30 shipped Quote Link to comment Share on other sites More sharing options...
gapanic Posted May 26, 2011 Author Report Share Posted May 26, 2011 Shocks are gone! Quote Link to comment Share on other sites More sharing options...
bigblockbanshee Posted May 26, 2011 Report Share Posted May 26, 2011 What is the diameter of the big end and is it possible to get an angle as well? Let me know, Chris. Quote Link to comment Share on other sites More sharing options...
gapanic Posted May 26, 2011 Author Report Share Posted May 26, 2011 What is the diameter of the big end and is it possible to get an angle as well? Let me know, Chris. Looks like it measures 3/8" at small end and 1" at big end. Pretty sure it is snap on part #r121. Don't know the angle but when I used it on my spindles I reamed to about 2" from the bottom of the reamer. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.