lonnied Posted February 24, 2011 Report Posted February 24, 2011 ok my banshee was set up for the last 7 years, carbs were gunked up and not working properly. I got a set of new stock carbs and put my jet kit in them, carbs seem to be working fine, set up hasent changed but its not running right. will start up on first kick but has no power and sounds really bogged down, smokes really bad and is running rich but no carb adjustments make a difference ie, adjust the fuel/air screw or idle, did a compression test and both cylinders are reading over 90. not really sure what to do, oh and put new spark plugs with no help, any comments or ideas are greatly appreciated, thanks! Quote
f00pda3w00p Posted February 24, 2011 Report Posted February 24, 2011 sounds like yur choke tube or you have an air leak somewhere Quote
06specialedition Posted February 24, 2011 Report Posted February 24, 2011 Are your carb slides synced? Choke tube in between both carbs? Quote
lonnied Posted February 24, 2011 Author Report Posted February 24, 2011 Are your carb slides synced? Choke tube in between both carbs? slides are synced and choke tube is in place Quote
Larry's Shee Posted February 24, 2011 Report Posted February 24, 2011 You will think I'm crazy, but pull your pipes off and check for mouse nests. Just a thought. Have heard of it before. Did you check that your jets were clean before you put them in? Then start going through all electical. Ohm stator, coil, cap. Make sure all grounds are clean, no rust. On my son's shee I had to clean rust off stator poles and lugs on outside of flywheel to clear up a one sided miss. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.