d-rock Posted November 15, 2010 Report Posted November 15, 2010 hey guys i am just wondering if the front brake senser would be cusing my banshee to boog out at low rpms. like when i take off it take a bit to get going seems realy slugish at frist but then it flys thanks d-rock Quote
Larry's Shee Posted November 15, 2010 Report Posted November 15, 2010 Has this problem just started or is it ongoing ? Has it been getting worse ? Have you recently changed ANYTHING on it ? Has the weather changed a lot ? Might try adjusting the idle air screw a little bit . If that doesn't do it clean carbs one at a time paying close attention to the pilot jet. JMHO , your results may vary. BTW , welcome to BHQ !! Quote
d-rock Posted November 15, 2010 Author Report Posted November 15, 2010 no has been for awile and the throttle 1 was messing things up to i took that off already and started running better but now its just at low rpms Quote
MikeNick Posted November 15, 2010 Report Posted November 15, 2010 There's no brake sensor on a Banshee. Sounds like your jetting is off. Quote
06specialedition Posted November 15, 2010 Report Posted November 15, 2010 There's no brake sensor on a Banshee. Sounds like your jetting is off. X2. Sounds like a jetting problem. Quote
d-rock Posted November 16, 2010 Author Report Posted November 16, 2010 there has to be like a kill switch on the front brake cus when it idels hi and hit the brake it dies down Quote
06specialedition Posted November 16, 2010 Report Posted November 16, 2010 there has to be like a kill switch on the front brake cus when it idels hi and hit the brake it dies down There is a rev limiter on your emergency brake. If your E brake is set...the bike won't hardly even rev up. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.