SPILTING CASES PROBLEMS!

[lt1maro]

Thanks to all that replied. I do have the that bearing retainer out and all the bolt i even went over in for the 10th time and nothing. I dont feel like im getting anywhere hitting it so i dont wanna keep doing it. does anyone have any tricks on how they spilt the cases.

[89 Banshee Man]

You need a manual? I have one in .pdf format.

[Larry's Shee]

Working with engine upsidedown support shafts with wood blocks. Run nuts down on studs till just before stud protrudes. Start tapping with rubber or dead blow , working around striking each one equally. Be sure cylinder studs will not hit. Another route would be brass punch and ballpeen hammer. Do not go ape shit at it. Look for the 11th time for bolts, there is one by rear mount and one by clutch release lever.