Jump to content

Recommended Posts

Posted

ok guys. this is what happened. i raced last week, my bike was alright. later in the night, i went to purge my bike, it wouldnt kick over. took my motor apart at the house,and a clip off the wristpin came off and scratched my right side cylinder up and piston. would anyone know how this could happen and anyone got any recommendations where to get them renikasiled ?

Posted

millienum plating most use

 

 

it it wasnt ported now is the time to get it ported and then replate it.

Posted

I have seen many clips spit out,whats your compression like in that cylinder,how bad is the cylinder,In an emergency race situation I have ran somepeoples bike with just throwing a new clip in so they can race,but compression was stil good,get in the habbit of rotating the clip 180 out from the hole by the wrist pin and make them all the same this way you know if they are moving when you rip it down.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...