themuffinman Posted March 23, 2010 Report Share Posted March 23, 2010 Where my header pipe meets the silencer leaks pretty bad, long story short there used to be a homemade rubber fitting with hose clamps over it but they're gone now. Anyone know the best way to fix it that will keep it looking clean? Second I just rebuilt my bike and it won't idle. It didn't idle when i got it but it blew up the day after so i figured the whole about to seize factor was the issue. Anyway I'm at about 300ft above sea level with stock carbs, full fmfs, wiesco pistons bored .06 over. Anyone know what my jets should be? What's a good kit to buy and how much is all this going to cost me? Quote Link to comment Share on other sites More sharing options...
sleeper06 Posted March 23, 2010 Report Share Posted March 23, 2010 Will it run at all,280 main,27.5 pilot,stock needle,on the rich side,no lid on box Quote Link to comment Share on other sites More sharing options...
themuffinman Posted March 24, 2010 Author Report Share Posted March 24, 2010 Will it run at all,280 main,27.5 pilot,stock needle,on the rich side,no lid on box It runs i just need to give it a little gas to get it to idle. I have new plugs and plenty of compression. i played with the throttle cable and idle screws but still can't get this thing to idle. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.