PT mid ranges W/boyesen

[yamaholic125]

hey guys im running boyesen Rad valves and PT midranges with stock carbs and a Pro design filter kit...pistons are .75 over..

 

im having hell of a time jetting my shee any ideas on jet sizes i should try?

 

also im at about 4400-4500 feet elevation

[Snopczynski]

there is a thread in the jetting section that has specs on just about every setup you can imagine.

[ELKARACING_SHEE]

hey guys im running boyesen Rad valves and PT midranges with stock carbs and a Pro design filter kit...pistons are .75 over..

 

im having hell of a time jetting my shee any ideas on jet sizes i should try?

 

also im at about 4400-4500 feet elevation

 

hey man, i see your from Alberta too. Where about are you located in Alberta? im from Calgary. Maybe you can meet up with one of us and give you out a hand

[Drewski]

hey guys im running boyesen Rad valves and PT midranges with stock carbs and a Pro design filter kit...pistons are .75 over..

 

im having hell of a time jetting my shee any ideas on jet sizes i should try?

 

also im at about 4400-4500 feet elevation

 

 

hey yamaholic your about 2000 feet off your elevation if you live in edmonton. the elevation is 2400 feet here!

[Drewski]

my bad, its 2192 feet

[yamaholic125]

my bad, its 2192 feet

 

 

HAHA i just realized...i mixed up my elevations..i was jetting my sled the same night and i got my papers mixed up...thanks ....hows the YFZ arms treating you?

[Drewski]

HAHA i just realized...i mixed up my elevations..i was jetting my sled the same night and i got my papers mixed up...thanks ....hows the YFZ arms treating you?

 

The shocks are not bad at all. I'm just a little bothered by the ride height being as low as it is. they will work just fine until next years LT set up I plan on doing to it.