Replace Swing Arm Bearings Steps

[FitZBanshEe]

I got a 02 banshee wanted a step by step on how to replace the swing arm bearings...thanks

[Hilarious]

I got a 02 banshee wanted a step by step on how to replace the swing arm bearings...thanks

 

the pivot bearings or carrier bearings? lol

i use a long socket wrench extension to beat the pivot bearings out. put the new bearings in the freezer

and press them into the swingarm. i usually do the same with the carrier bearings. be very generous

with the grease during reassembly also.

[FitZBanshEe]

I meant bushings...and I got the kit I need step

by step never done these before

[fastbanshee8]

Buy a Clymer's manual. That is one thing a Banshee owner should be required to buy.

[Hilarious]

I meant bushings...and I got the kit I need step

by step never done these before

 

i am not sure what bushings you are referring to other than maybe the shock linkage/dogbone?

can you post a picture of what you are tring to replace?

all the pieces in the rear end/swingarm are pretty cut and dry as far as replacement goes.

[philly]

hopefully yours arnt rusted in. 2 years ago i had to cut the bolt holding the swingarm off,. that was not fun. so i tear it all down tonight to paint with POR15 and the damn bolt is rusted in there again..