Help

[Drag618]

This is my first post. I always have came here and looked for answers and usually find them.

 

Just recently got my motor back from being rebuilt from bottom to top. 4mil and port work.

 

I assembled the motor back to the frame and hooked up all the wireing.

 

Banshee started 1st kick and idled.

 

I warmed the motor up took it for a short ride. Everything was fine. Let cool down checked fluids, and Started it again. warmed motor up for a second time ran good for a few minutes... I then accelerated and was at about 3/4 throttle and it missed or backfired and died. started trying to kick start it but would not start.. head lights would light up as i kicked..

 

I have no spark.

 

Tried a friends coil it didnt work. Tried a friends cdi it didnt work. Tried a friends run switch it didnt work. by passed the key it did not work.

 

Everything looks good as far as wireing. or at least i think..

 

what do i need to look at? what could have happened? and help would be appreciated..

[AKheathen]

cheack and see if your flywhel came loose or something

[bansheesandrider]

Also check your stator- put an ohm meter on the wires per yhe manual or search on here for the specs. The stator has 2 seperate circuits. one for the lights and one for the ignition. So your lights can still come on when kicking it but the ignition side can be bad.