Axle swap

[Epd711]

I'm tryin to get the stock axle out and the sprocket hub won't budge. Any tips? There isnt a clip or something I'm missing is there? Right now I sprayed PB Blaster and I'm lettin it sit for the night.

 

I've swapped axles in a few of my older quads usually no porblems but this dang sprocket hub will not move at all.

Any help appreciated -thanks.

[99bansheeboy]

did you take the skid plate off ??

[98_shee]

After you take the nuts off it should slide off. If the pb blaster don't work, Try taking the carrier off, put a block on the ground stand the axle and carrier straight up and slam it down in the block it should break it loose.

[crustydemon]

Soak it real good overnight and tap on it a bit, It will come off. There are no clips on it. I've had a few stubborn ones in the past.

[bbcmudtruck]

did you take the skid plate off ??

 

 

[SAVAGE420]

 

X10

[98_shee]

did you take the skid plate off ??

 

 

[99bansheeboy]

ha ha ha ha ha...what are you guys laughing at ..... .... ..... ....

[SAVAGE420]

ha ha ha ha ha...what are you guys laughing at ..... .... ..... ....

 

At your comment about taking the skid off to get the axle off....what the hell is with that man?

[Epd711]

Well after trying a few different ways, still no luck, this thing is on there.

I even took the carrier assembly off the swingarm put it in a press and no luck.

Took it to the local dealer where my friends work, no one there could get it off either.

What now? Any suggestions anyone?

[AKheathen]

heat up the hub real good, put the wheel hub nut on the endwith a socket on it. set it on the concrete, and beat the carrier down......it should pop off, or at least start moving........at least you know the splines aren't worn out.