FitZBanshEe Posted October 26, 2009 Report Posted October 26, 2009 Someone please help!!... i did a motor swap on my banshee and i went to fire it up and it started and it died after about 5 seconds... then it wouldnt kick start after... so i roll start it and it starts right up but its really boggy in low speeds and will only idle with the choke on... i cleaned the carbs re jetted it and brand new spark plugs tested for spark... wtf is wrong this thing Quote
flyhighprerunner Posted October 26, 2009 Report Posted October 26, 2009 Whats your jetting, your elevation? What mods are done to the bike? Did the bike run fine before the motor swap? Did you mess with the timing at all? did you check for any leaks (air leaks)? Quote
98_shee Posted October 26, 2009 Report Posted October 26, 2009 Did you put the balance tube back between the carbs? Quote
Doddy Posted October 26, 2009 Report Posted October 26, 2009 Did you put the slides in the correct carbs? If you get them backwards you will have a similar problem. Quote
Koolguyson Posted October 27, 2009 Report Posted October 27, 2009 Low compression will cause that issue as well. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.