Burt Reynolds Posted October 4, 2009 Report Posted October 4, 2009 Ok i have a set of denton racing j arms on my banshee. They have bronze bushings. Well they are worn out so i bought some stock style delron j arm bushings. Come to find out the denton j arms use a different size bushing,they have a little bit of a smaller outer diameter,but have the same inner diameter so you can use the stock banshee bolt and tube. I measured the stock banshee j arm tube,where the bushing pushes in,it is just over 20mm. The denton racing tube where the bushing pushes in is roughly 18.7mm I have tried and tried to find something on denton racing,but i think they are gone,the website doesnt work and the phone number i found is disconnected.Also i cant find any of their products besides the stabilizer anywhere. So WTF can i do? I could have a machine shop machine the tubes to where they will work with stock bushings,and still be strong(they have a thick wall),but i would rather find some bushings that will work? Anyone ever heard of this? This is a damn headache Quote
SAVAGE420 Posted October 4, 2009 Report Posted October 4, 2009 (edited) Just be careful and use a dremel with a lil sanding wheel drum to take a lil bit off the outsides of them all the way around slowly. Simple fix and will take 1/2 an hour at the most to do them all. If no dremel then use a drill with a lil sanding wheel drum..come on now ELI!!!! Edited October 4, 2009 by savage420 Quote
JKJK Posted October 4, 2009 Report Posted October 4, 2009 Richard's Bushings 413-443-1141 In Pittsfield Ma.Give Rich a call,he's a good guy+probably has what you need. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.