03cobra283 Posted September 27, 2009 Report Posted September 27, 2009 I am new here and have a stock 2001 banshee. I just recently purchased the t-6 kit and installed it. After I put everything in the quad wont start. I Know its a fuel problem cause it will run if fuel is sprayed into the carbs. I installed the needle the way the instructions said. They say to put the clip on the fourth groove which I did, so Im not sure on what could be the hold up? Any help would be great. Thanks Quote
Toomey Banshee Posted September 27, 2009 Report Posted September 27, 2009 Are the slides in the right way? Is the tube connected between the two carbs? Did you unplug the TORS? Parking brake unplugged? Quote
99bansheeboy Posted September 27, 2009 Report Posted September 27, 2009 did you connect the balance tube because mine wouldnt start then i attached it and it started Quote
03cobra283 Posted September 29, 2009 Author Report Posted September 29, 2009 (edited) The bike has a parking brake delete plate not sure if that will do anything? All I did was unscrew the slide at the top of the carbs the slides when I went and put them back in only would allow me to put them in one way. So I am thinking they are in correct. Im gonna go check now. Edited September 29, 2009 by 03cobra283 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.