VegasJeff Posted September 1, 2009 Report Posted September 1, 2009 I recently purchased a pancake bearing from rdz and they just sent the flat roller bearing and a washer,The ones I've bought before were complete. when installing the stock adjustment bolt with the new roller and washer,do you have to drill out the center of the preassure plate to allow the bearing to spin freely? If not it will just make contact where the hex bolt goes through the preassure plate. Thanks Jeff.. Quote
Rodneya Posted September 1, 2009 Report Posted September 1, 2009 Mine came like that too and I did not have to drill anything. just leave off the washer where the locknut goes on. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.