ws6onslicks Posted August 20, 2009 Report Posted August 20, 2009 So I have seen a few other guys with this problem where only one side is firing. Now I have recently gotten my banshee and doesnt seem to have much work done to it. So I am just looking for some advice as to where to start looking first... The plugs are good but havent had the time to get into much else. Quote
T_Shee Posted August 20, 2009 Report Posted August 20, 2009 start with new plugs. then swap plug wires from one side to the other and see if it changes the miss. after that i would suggest a compressions check, clean carbs really good, make sure both slides are moving up and down,check reeds etc etc Quote
ws6onslicks Posted August 21, 2009 Author Report Posted August 21, 2009 start with new plugs. then swap plug wires from one side to the other and see if it changes the miss. after that i would suggest a compressions check, clean carbs really good, make sure both slides are moving up and down,check reeds etc etc Ok thanks man. What is the best way to clean the carbs (while making sure to keep them synchronized)? Is there a sticky or anything? Quote
T_Shee Posted August 23, 2009 Report Posted August 23, 2009 should be plenty of info on here about it. as long as you dont mess with the cable adjusters you wont have to worry about them getting out of xync. if you are confident you can do it right then just take the bowls off the bottom of the carbs and spray carb cleaner throug the jets and all the orifices. its pretty simple just make sure you get everything back the way it was Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.