of course another jetting need

[klemet banshee]

i got most of the jetting zeroed in. its still sluggish off the bottom end and jus looking if i should go lower. there was a 65 pilot and i dropped to a 58 and it made a shit load diffrence should i go lower or jus play with the needle? its on the middle clip

 

also its 2 into 1 with fmf pipes kn pod with outerwear agrresive trail port shaved head stock stroke

 

 

note*** i dont have the lectron on now its a 36 pwk

Edited August 6, 2009 by klemet banshee

[Sammy]

Lean your clip out one notch and see how it runs. Since you have a trail port there should be no sluggishness down low. It should pretty much be instantaneous power delivery. Also I would highly recommend against the Dynoport 2>1 pipe. It has been proven to not perform that well. I would go with some Pro Circuits platinum's or PT mids. I didn't see in your sig what type of reed your running either. Hopefully it's a good low tension reed. Like a Boyesen or carbon tech.

[trex banshee]

David,

 

What do you have the timing set on? Its going to want some advance, +4 would be great. Also, if you can get a hold of some i strongly recommend 28pwks. Great carb for that porting.