Driggs Posted August 4, 2009 Report Posted August 4, 2009 Just got my kit today. Question, do the springs press up into the new cap and I do away with the piece that the spring use to butt up against (the piece that use to go up into the cap)? Quote
LiftdT4R Posted August 5, 2009 Report Posted August 5, 2009 The spring does just sit in the top of the cap, its a spring so nothing really hold it there. But there should be a rubber type washer that sits in there too(that will be the only thing there), but if you dont have it its not super important. Quote
creiss13 Posted August 5, 2009 Report Posted August 5, 2009 Just got my kit today. Question, do the springs press up into the new cap and I do away with the piece that the spring use to butt up against (the piece that use to go up into the cap)? Hey I am looking to eliminate my tors, where did you get a kit, how much and how hard is it? Thanks Quote
LiftdT4R Posted August 5, 2009 Report Posted August 5, 2009 I think Vito's sells them. Its not super hard, but you do have to tap a screw into the side of the carb. If you keep your eyes open on fleabay and here you can usually find a set of carbs with the tors removed for as much or less then the kit costs, that way you have a spare set at least. Quote
Driggs Posted August 5, 2009 Author Report Posted August 5, 2009 Thanks for the info. I got mine from eBay for $50. It's not hard at all to install, just take your time and READ THE DIRECTIONS. I f'd up, tried to over tap the hole and broke the tap inside the hole!!! When it stops, you might think you can tap it further, but STOP. I had to order a new carb because I didn Quote
LiftdT4R Posted August 5, 2009 Report Posted August 5, 2009 And make sure that you tap the correct side of the carb too. I had a errr friend that err tapped the wrong side. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.