Beachcruiser Posted August 9, 2009 Author Report Posted August 9, 2009 I was finally able to start tinkering with the banshee. Did a compression check and both cylinders read 120........what a new top end, port and milled head what should it be around? Quote
SAVAGE420 Posted August 10, 2009 Report Posted August 10, 2009 Could this low compression be one of the problems for the mid range studder? No, jetting is. What needle you running? What clip position? Quote
Beachcruiser Posted August 10, 2009 Author Report Posted August 10, 2009 No, jetting is. What needle you running? What clip position? I'm pretty sure it's the stock needle. Currently set on the top clip (leanest). I started off in the middle but it ran worst than when it was leaner. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.