PROBLEMS SHIFTING

[ROBK]

Hello Banshee masters,

 

A quick question for you guys, im having problems shifting when im in hi rev,

then I have to let off the throttle and almost force it into the next gear.

 

Only having this problem in 3rd, 4th, 5th, 6th

 

Time to replace clutch?

 

 

I am not sure what the problem is, If someone can help me out that would be great,

 

Thank you,

Rob

[okbeast]

Get you a Clymers, you can download one off the site somewhere. Check all the adjustments in your clutch from the clutch arm on top of the cases to the shift shaft and eccentric nut.

[yamaha11]

do you have a high hp motor, cuz mine did this when i had a stock trans in my motor that made 76 hp on the dyno and it would not shift worth a shit

[ROBK]

do you have a high hp motor, cuz mine did this when i had a stock trans in my motor that made 76 hp on the dyno and it would not shift worth a shit

 

 

 

THANKS GUYS,

 

I will check all adjustments again,

as for the motor its not a high hp motor.

fmf pipes

v force reeds

I think the carbs have been changed

and a mild port job when I got the top end done.

 

I dont know much about this quad, just learning from this site

 

I guess I have one more question,

 

Adjustable timing plate ? please tell me your thoughts,

 

Once again Thank you for all the help

 

Rob

[okbeast]

Timing plates are a cheap bang for your buck. Get it, and a flywheel puller (banshee only, no 3-prong puller) and slap the timing plate on, set it at +4 or so and go from there. It'll give ya some more bottom end and power all over.

[ROBK]

Wouldnt happen to know where I can get the timing plate on line ??????

[okbeast]

http://cgi.ebay.com/ebaymotors/NEW-ADJUSTA...%3A1|240%3A1318

 

Chariot Performance has a nice product but I can never find his website or ebay page.

 

Just kidding, here's the chariot piece.

 

http://cgi.ebay.com/ebaymotors/Banshee-606...%3A1|240%3A1318

Edited June 1, 2009 by okbeast