bassmaster345 Posted April 15, 2009 Report Posted April 15, 2009 Well finally got all my parts to start putting my engine back together. Any tips from the pro's on sealing the cases back together? Got it all cleaned up good, trans is sitting in and new crank is in with all new seals. What do you guys wipe the sealing surface down with before sealing? Is there any adjustments or things to make sure is done before sealing it together? This is my first rebuild so any pointers will be much appreciated. Quote
banshee_terror_ Posted April 15, 2009 Report Posted April 15, 2009 i just sealed around the whole cases with some permitex. i cleaned were im going to be silaconing up with rubbing alchol first also just because i didnt specify were i put the silicone. i put it on every spot were the cases touch Quote
bassmaster345 Posted April 15, 2009 Author Report Posted April 15, 2009 I purchased some K&S oil seals and was needing to know on the left hand crank seal what side faces out? My Clymers manual says to put the side with the green dot out but these are not marked that way. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.