need some help

[bakersfieldturbo]

ok well my bike was over heating so i decided to rip it apart and buy some new parts. my mods are in my sig.... but i took off the trinity stage IV head.. but how do i get it apart it seems to be stuck together... and then when i called trinity they said all i needed was oring kit .. but any who i was told that with a trinity head i dont need to have a head gasket but when i took off the head there was a gasket... but my question to you guys is do i need to put a new gasket or should it have not been there .. if i need a head gasket if you guys could tell me which one i need... my bore is a 66.00mm/2.00mm.. and where i can get it at... also how do i get the head apart.... thanks .. banshee hq..

[Bill]

The Trinity head should only require o-rings, thats all I run on mine.

[bakersfieldturbo]

The Trinity head should only require o-rings, thats all I run on mine.

 

ok well how do i get the head open.. and i guess what i mean is it goes the head stright ontop of the cylanders.? or does it go head . gasket. cylanders?

[sheefreak]

No gasket bro. That may be why it is overheating, but could possibly have other issues as well. It goes head, orings, jugs....

[AKheathen]

ok well how do i get the head open.. and i guess what i mean is it goes the head stright ontop of the cylanders.? or does it go head . gasket. cylanders?

ok, i'm not 100% on the trinity head, but it should be held together with dowels on either side. push the domes out through the bottom and you can get a heel bar in there an gently ease the 2 halfs apart. be carefull not to damage either edge.

[Bill]

To split the head apart once you get it off the cylinders you just take the two allen head bolts off that are holding the down spout on, I dont think thats what its called but you know what I mean right?