sheething1127 Posted January 25, 2009 Report Share Posted January 25, 2009 ok guys so heres the deal the parking brake on my banshee is a P.O.S. i want to put the block off kit on my rear caliper and eliminate the parking brake. i know that on the banshee there is a electrical part of the paking brake. so my question is can it all be removed without the TORS eliminator kit. if i leave the actual controls on my handlebars and just take tha calble out and block off the rear will that work? thanks guys. Quote Link to comment Share on other sites More sharing options...
Michael Jackson Posted January 25, 2009 Report Share Posted January 25, 2009 u gota unplug the connection on the sensor that runs up to the perch, its about a foot down on the extra wire that runs up to the perch, if u dont unplug it it wont rev, other than that, just rip everything out and put ur new plate on Quote Link to comment Share on other sites More sharing options...
shee screams Posted January 26, 2009 Report Share Posted January 26, 2009 I took my cable off, an took a disk grinder to the part on my handle bars that held the cable, I did the same to the part on the back end, and just caped off the hole. I repainted them both, it looks good, and gets rid of the park brake at no cost! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.