JEFF C Posted January 21, 2009 Report Posted January 21, 2009 ok guys here is what i have done so far -replaced stator-new -replaced coil-new replaced CDI -new -tested kill switch -tested pick up coil -eliminated key switch -and eliminated the TORS I have done all the tests that I was told to do,and it all tested OK Everything was running fine, until I tried to turn it off by the key and it did not turn off. turned it off with the kill switch and it would not start again. but if I bump start it, it will run. ps. it has low compression - could that be affecting my spark??? thanks jeff Quote
lowbuckracing Posted January 21, 2009 Report Posted January 21, 2009 How low of compression?,The spark would still be strong with no pistons attached....What is the gap between the pickup and balancer?Check your ground wire on loom?Good luck. Quote
BUILDER Posted January 21, 2009 Report Posted January 21, 2009 ok guys here is what i have done so far-replaced stator-new -replaced coil-new replaced CDI -new -tested kill switch -tested pick up coil -eliminated key switch -and eliminated the TORS I have done all the tests that I was told to do,and it all tested OK Everything was running fine, until I tried to turn it off by the key and it did not turn off. turned it off with the kill switch and it would not start again. but if I bump start it, it will run. ps. it has low compression - could that be affecting my spark??? thanks jeff If you have low compression towing it to start it will work because it gets the pistons moving fast enough to get it to fire up. When you say you have no spark but it will start if you tow it dont sound right. Have you pulled the plugs and kicked it over to see if they are firing? Quote
JEFF C Posted January 21, 2009 Author Report Posted January 21, 2009 compression is at 60 lbs,the gap is the thickness of a busisness card,dont own feeler gauges yet, How low of compression?,The spark would still be strong with no pistons attached....What is the gap between the pickup and balancer?Check your ground wire on loom?Good luck. Quote
JEFF C Posted January 21, 2009 Author Report Posted January 21, 2009 yes i pulled the plugs,no spark,Were would i fine the main ground wire that mounts to the frame If you have low compression towing it to start it will work because it gets the pistons moving fast enough to get it to fire up. When you say you have no spark but it will start if you tow it dont sound right. Have you pulled the plugs and kicked it over to see if they are firing? Quote
BUILDER Posted January 21, 2009 Report Posted January 21, 2009 compression is at 60 lbs,the gap is the thickness of a busisness card,dont own feeler gauges yet, O that is not good at all 60 pounds is way low. Quote
magz Posted January 21, 2009 Report Posted January 21, 2009 jesus, man rebuild the topend and take back all the shit you baught, i wouldnt even try running a motors with lower then 90 psi Quote
JEFF C Posted January 21, 2009 Author Report Posted January 21, 2009 yes i know ,but wanted to fix this no spark thing first,befor i rebuild the tpo end O that is not good at all 60 pounds is way low. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.