4 mill stock rod motor barebones

[[email protected]]

On the quest.

 

Heres the specs best to knowledge:

 

4 mill stock rod , VITO but it might be HOT ROD ( i have to check ) .

65.55 bore** have to check but its no where near last bore. , full drag port , 99performance , ( has the boost ports on intake )

 

Pistons are ported to match sleeves and intake ports,

Clutch, Billet basket ( hinson ) brand new clutch pads , and a direct drive lockup .

Tranny is bone stock , and shifts FINE under full load of power.

Has case saver

17t ( used 17.40 )

Lightend flywheel

timing plate at +10'

billet shifter included !

 

Bike ran great on race gas and has not seen much use.

 

I have the cool head and side clutch cover for sale in other posts. I was taking apart the motor to get it all chrome/polished but then decided its time to upgrade to a waaaaaaaaay bigger motor. your loss my gain . Ship us only , paypal only !

 

 

1125 shipped

 

 

[NYUK]

cutty. stop hoggin the board. edit your shit and make one ad.

[[email protected]]

cutty. stop hoggin the board. edit your shit and make one ad.

 

My applogies sir .

 

 

 

1075

 

 

[tony cub]

how long ago did 99 port these?

[[email protected]]

a solid year + , these cyls seen 20 hours of use since portjob. Not much use for a banshee living on the beach.

[ex400]

do you have any more picture of that frame those chains look sick.

[[email protected]]

do you have any more picture of that frame those chains look sick.

 

 

No im trying to sell something here , the frame is off limits.

[trex banshee]

not to be a dick or anything but just to make sure people are not misinformed....that port job is pretty rough looking. Far from a full drag port if you ask me.