pvl ignition

[lsr_banshee]

hey guys new member here so bare with my first post, does anyone have pics of how they mounted their pvl ignition and also do I need to do anything special to hook up a pro design tether to it? thanks any help is appreciated

[wesw]

there are holes where stock coil was you can mount one there, i think that was the right side, and theres a spot on the left side, i think i drilled it out to make room for a bolt to go thru. i made sure there was a good ground on both coils,

 

you will need to wire 2 kill switchs or as you want 2 tether switches i think or wire them to kill both coils.

 

what are you going to set your timing at in MM??

[lsr_banshee]

there are holes where stock coil was you can mount one there, i think that was the right side, and theres a spot on the left side, i think i drilled it out to make room for a bolt to go thru. i made sure there was a good ground on both coils,

 

you will need to wire 2 kill switchs or as you want 2 tether switches i think or wire them to kill both coils.

 

what are you going to set your timing at in MM??

not sure where to set timing, any ideas?

[wesw]

was told 1.85mm before tdc was +7 degrees.

 

all depends on what your going to do and what fuel your domes blah blah talk to you builder and go from there.