And im in deep!

[OKCterror]

Got all my new mods in, billet impellar, stator plate at +4, vf3's, coolhead with 19cc, and pingle petcock. Started it up and it idles ok. But the left pipe gets hot and not the right. Runs rough while driving and can barely keep it alive when im moving. Advice. Running stock carbs with 310s, pods, and everything else below. Help me out guys

[THE GRIM RIPPER]

If your @ or a little above sea level 310's seem lean... but I think one of your carbs mains sounds like its clogged if the pipe is getting extremely hot. Pull the bowl off and check that out.

[OKCterror]

would that explain the rough running

[some87]

well if one side is not running it will run rough. i did that with one of my spark plugs after i changed them out and i forgot to plug the wire in. it still ran but ran like crap

[AKheathen]

Got all my new mods in, billet impellar, stator plate at +4, vf3's, coolhead with 19cc, and pingle petcock. Started it up and it idles ok. But the left pipe gets hot and not the right. Runs rough while driving and can barely keep it alive when im moving. Advice. Running stock carbs with 310s, pods, and everything else below. Help me out guys

what fuel are you running? chech your choke tube and pull the pods to check that the slides are mooving right.

[magz]

make sure there gas in both carbs also, maybe 1 carb isnt filling up the bowl with gas, drain a little out the bottom screw hole.

[1996dragshee]

pull your carbs and clean em..one grain of sand or dirt in the needle seat can clog your shit..have you always been running 310s? how do your plugs look?

[OKCterror]

they all look good, gonna pull the carbs and clean em

[MikeNick]

My bike was running horribly a few weeks ago and some friends figured out that I had a fouled plug. 1 pipe was hot 1 wasnt and it would run but when you got past 1/2 throttle it would cut out..