scotts96fast Posted August 30, 2008 Report Posted August 30, 2008 The banshee died two different weekends,there was no spark.replaced coil and clean all wired ends.still no spark.Took run /off control off and cleaned.fired and ran great all weekend. Next trip same thing happened lost spark a few miles down the trail.remove run/off control and cleaned.nothing!!!messed around for hours and no spark.Went to the bar came back, first kick fired and ran great all weekend!!!WTF???? So now it runs great,BUT headlights go off when pulling in the clutch.Also headlights flicker on and off. Quote
THE GRIM RIPPER Posted August 30, 2008 Report Posted August 30, 2008 Assuming you still have the stock clutch perch assembly?... Your shorting out somewhere in your harness or in your kill/run switch box... Look for frayed wires and a good place to start would be where all your wires funnel down thru near your steering stem... Quote
scotts96fast Posted September 2, 2008 Author Report Posted September 2, 2008 I use the easy pull lever.I figured out you can unplug the run/off control,and the machine should run. I just can't see what the clutch has to do with the headlights?? Quote
scotts96fast Posted September 5, 2008 Author Report Posted September 5, 2008 no one has any ideas huh?? Quote
spurdy Posted September 5, 2008 Report Posted September 5, 2008 no one has any ideas huh?? I would guess that movement from your clutch actuator (top of your case) or the clutch cable is moving your wiring or harness causing the short or open circuit. SP Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.