njbansheerider

where u from

i bought a surplus lot of blue point impact wrenchs. i bought it for the the 1" and 3/4" wrenchs i need for my truck tire shop but had to take the hole lot. what i am selling are Impact Wrench, Air, Heavy Duty, 3/8" Drive (20-125 ft. lb.) they sell for 179.99 if u buy it from the snapon man i am selling them for $100 ec and i got a air grease gun from blue point. i am selling that for $55

i got a rolling 400ex i will trade u

i got a banshee motor that has low hours on it email me back at njredridez@aol.com

i got a mx ready banshee that i will sell to u. has a ton of work done to it if u are still looking for one email me at njredridez@aol.com

http://cgi.ebay.com/ebaymotors/ws/eBayISAP...ssPageName=WDVW http://cgi.ebay.com/ebaymotors/ws/eBayISAP...ssPageName=WDVW http://cgi.ebay.com/ebaymotors/ws/eBayISAP...B%3ALC%3AMT%3A1 2004 sub frame http://cgi.ebay.com/ebaymotors/ws/eBayISAP...B%3ALC%3AMT%3A1

bump i will have alot more stuff to sell once the banshee motor is gone

another thing that will help in the turns on ur banshee stay on the gas more and use the clutch to slow down

i got on national built motor off a blaster http://cgi.ebay.com/ebaymotors/ws/eBayISAP...me=STRK:MESE:IT and on drag ported banshee motor. banshee motor that was built by Dan Hull at A&S banshee racing.this motor has a ton of work done to it. the motor is 20 over with a&s banshee modded wiseco pistons to match the port sizes and have been lightened. it has a duncan racing power head with 19cc domes cut down to 14cc domes. the motor has been ported and polished for drag. it is a level 6 port job welding & reshaping of transfers.Cut & Rechamber head. port matched cases. hinson clutch basket and barntte clutch. it has a hot rods trued and welded crank. it has shift star mod. v force reeds. pro design water pump impeller and pro desigh ez drain plate. it has a case saver to keep the chain from breaking the case. white brothers boost bottle and stock intakes. ricky stator high output stator and timming plate that gots from -10 to +10. the trans has been serviced and all seals have been change and the motor is still running great. this motor was made to run on race gas, alky or meth. only. this bike was dynoed at 86 hp running on 110 octane fuel. i ran motul 2 cycle oil at 32:1and motul trans oil. the is prob somethings i am forgetting. make some offer!!!! and one tc yfz450 racing exhaust $400

http://cgi.ebay.com/ebaymotors/ws/eBayISAP...me=STRK:MESE:IT

bump

u want it to sit 2 to 3 degrees something like that what i use is a big squate and make the top 1/4 in more to a 1/2in in then the bottom

i am selling 1998 ford tuarus it has a v6 in it with a 149000 miles on it. still runs stronge. i want 2500 OBO for it if u have any ???? u and call me at 609 929 8884 or email me about it

i got a a&s built banshee motor i will sell u for 1500

can u take some pic of it and what is wrong with it