Silverlake

Yes and they get stuck, maybe theyre gummed up. How do i slow the idle down?

I feel like my banshee is idling tok fast, after watching banshee videos and going up to silverlake my banshee seems to idle fast, and my idle screws wont turn in my carbs, i think theyre stuck. How do you slow down the idle for the bike? Both screws are almost all the way in the carb and im running stock carbs with 270 main 27.5 pilot, and needle in middle clip

Just changed out the pilots to 27.5, the bike seems to be idling faster aswell as my left carb is leaking now, it looks like i may have not tightened up the screws enough

Banshee bogs out in the sand in first gear, paddles will turn slowly and boggy until i hit the powerband then it rips my arms off lol. Running 270 mains, 25 pilots, needle in middle clip, and they are mikuni stock 26 mm carbs, i do not know the gear ratio, im running skat trak haulers 8 paddle, and i have fmf gold series exhaust, v fkrce three reeds, stock airbox with lid, any advice helps

Yeah i feel a lack of power in the bottom end, mid range and top are good and the bottom end just falls on its face

Skat trak 8 paddle, and gearing im not too sure on, i think 15 or 14 in the front and no clue on rear

Aswell I checked the new plugs that I put in and theyre nice and golden brown on the lower part of the electrode ( further away from the ground)

Just changed my jetting before heading up to silverlake, stock banshee mikuni 26mm carbs, fmf fatty pipes and silencers, v force 3 reeds, stock airbox and lid, have 270 mains, stock pilots and needle clip in middle position. For whatever reason i couldnt spin the paddles from a stand still if my life depended on it while i was in the dunes, 8 paddle skat trak haulers, I tried dumping the clutch and it still bogged down and wouldnt spin the tires quicky at all. Does anyone know whats going on?

I have stock 26 mikuni carbs, but they have a 142 jet in them, I want to know what size 142 is in the hex jets so yes,

I checked the main jets in my banshee and they are 142, what in terms of hex jet size is that? I want to go to 270 main hex jets and. I want to know what 142 mains are, all advice is helpful, thanks

Stock 26 mm mikuni

Stock 26 mm mikuni

It's too rich, Honestly I checked the mains and they weren't hex jets and im not really sure of the size because they didnt have 270 for example on it, I beleive it said 18, as it was a round jet with a line through it

Perfect thankyou, I know how to do plug chops and everything it was just getting the jets all in line first

Stock carbs, no port, 600 ft above sea level