hi, im pulling my hair out with this banshee i bought. it seems to be one thing after another. currently the issue is that when i open it up only one cylinder is firing at full potential. i have replaced everything internally due to the top end blowing apart a week after i bought it. i have gone through the carbs numerous times. i just replaced the coil, and plugs. im officially getting spark when i turn it over, and both cylinders fire just fine at low rpms. but when i get on it, it feels and acts like it has half the power it should. and when i reach down and touch the pipes after a pull only one is red hot. im at a loss.only thing i can think of is the stator. but seeing as im new to banshees i was hoping someone could lend some insight.
i have: prodesign cool head, toomey t5 pipes, bored to 65mm and ported cylinders, wiseco pistons, ngk plug wires and boots, and 280 jets.. if any of this helps